Welcome to the LX Forum - Dodge Charger | Dodge Challenger | Dodge Magnum | Chrysler 300 Forum.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   LX Forum - Dodge Charger | Dodge Challenger | Dodge Magnum | Chrysler 300 Forum > LX Forum - Modifications > Engine & Performance Modifications

Engine & Performance Modifications Discuss Engine Performance mods here. From superchargers, turbo, twin turbos, exhaust, chips, headers, and more.


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 09-16-2010, 04:29 PM   #1
 
BOS/SRT's Avatar
BOS/SRT
Administrator
 
Join Date: Feb 2010
Location: Boston
Name: Jimmy
Posts: 601

Car Model: Dodge Charger SRT8
Year: 2006
Engine: 6.1L HEMI
Default DMH Low Profile Electric Cutouts - Write Up
I got the cutouts today, still waiting on new mounting plates from DMH and upgraded gasket from Modern Muscle. I should have the new mounting plate by Friday with they're gasket, which I will use untill MM gasket comes in, then I will swap.

Since the low pro cutouts are used I cleaned them thoroughly and tested them out and both are working great. Although I noticed that one cutout is slower than the other, not sure if it's an issu. Actually the movement is the same speed, just that one is slightly delayed.

I misunderstood from previous theads on what was needed to run the wiring properly. I had thought that they required a 30a fuse, but not so, they only require a 20a. I decided to wire the same as everyone else, tapping into the cig lighter, which is already 20a. I never used the lighter and I always charge my cell from the arm rest connect. So I tapped the positive into the positive line for the lighter and ground as well. Didn't seem like there was a reason for mento ground it anywhere else. I removed the lighter connect and is zipped with cutout wire, tucked in. I also couldn't decide where to place the switch, didn't want to drill any holes on panels or bezels and plan on eventually doing a BT switch plate. So for now, I removed the actual lighter assembly, which left a hole for me to place the switch for now. The hole is a little bigger, so tomorrow I will find away to secure it in place.

Of course I tested the cutouts multiple times during installing the wire and switch and all is working perfectly. I hope to have the cutouts installed on Monday or possibly Saturday, depending on when the mounting plate gets here. Once it's in I will post pix of setup and video for sound difference.

Thanks to all that put in they're input and special thanks to STROGUY (Randy) for his patience and guidance.


__________________
Jimmy - BRIGHT SILVER METALLIC SRT8 I,II,III
2toned Flat Black Vinyl,CarbonbyDesign,Billet Tech Designer,Razor Edge,SpeedLogix,KW v2,Predator 91 tune,22" 3 pc Covet Forged Wheels ,Nitto 420s,BWoody Sway ends,Hotchkis sways,Magnaflow highflow/c-back,DMH electric cutouts,22elite,BND ALL Quantum Blue/ACESIV,Killerglass,GSM intake,Danko v2 spoiler/Chin spoiler,Grip Rockers,Neffywrap
BOS/SRT is offline   Reply With Quote
 

Bookmarks


Currently Active Users Viewing This Thread: 2 (0 members and 2 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump