Welcome to the LX Forum - Dodge Charger | Dodge Challenger | Dodge Magnum | Chrysler 300 Forum.
If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
The next step is to connect al the dots (just like they made you do in Math class on a graph. I'm gonna use 2" tape, because the width helps me keep a straight line. The idea is to cross all the measurment hash marks keeping is as straight as possible
Now, I spray it with paint to mark the spot to cut and cut it off with an air powered hack saw. I'm now ready to install the liner back into the car and mount the wide body so i can design the LAST piece of this project - Moulds should be in full production by the end of the year!!
Here I'm taking a template off the driver's side so I know exactly where to cut the sheet metal on the other side. These Template will come with the Tub Kit if you get that option.