Welcome to the LX Forum - Dodge Charger | Dodge Challenger | Dodge Magnum | Chrysler 300 Forum.
If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
We stalled the build for a bit to get some new people on board and it has changed some things all for the better. As in my other post the wheels I thought would work will require a spacer and I'm not running with spacers. Also Taylor Racing did not return our calls so we are moving on, I looked into the PPP 373 with driveshaft setup, but that has evolved into one of the people on the build deciding to build me one themselves given the fact that my engine has also been changed due to a really nice set of pistons becomming avialable so the 426 stroker is out. I can not give the specs on the motor till the builders of the rotating ass, and heads gives the OK I know sounds off but I will post the tech specs and sheets as soon as I can. Man builds are always so fluid I should prolly just shut up till it's done but it's just to exciting, ok some pics, Oh we're dropping the rear and the engine / tranny on monday I'll update pics then.
Threaded Mode